| Browse By Category |
|
|
|
| VIDEO & INFO |
|
|
|
 |
| |
|
|
| WARRANTY |
|
3 YEAR WARRANTY 12000LB
CONTROL BOX ELECTRICAL 6 MONTHS
WIRELESS REMOTE 6 MONTHS
support@tigerz11.com.au
Buyer pays for OF ALL postage costs relating to any faulty parts that need to be returned for repairs
Buyer pays for OF ALL postage costs relating to any parts
or repaired parts that need to be posted out No exceptions
Warranty concerns, you need to phone BEN 0424256939.
Warranty covers
WARRANTY COVERS FAULTY WORKMANSHIP
WARRANTY DOES NOT COVER MISUSE BY THE OPERATOR
Warranty does not cover the winch casing
Solenoids are not covered under warranty
A problem with a cracked casing is when reeling in the cable; REPAIR COST & PARTS $80
It is not evenly disbursed over the drum.
Caused by operator not concentrating
Do not operate winch with cable fully out, leave 5 wraps on the drum.
There is red marking where you do not go past when reeling in under load; this is all in the manual
When you purchase the winch you will be emailed a video clip of how
To wire up and the operation of the winch.
The common problem with all winches is the
Operator, why, because he knows everything, he has been
A mechanic or is a mechanic, he has worked with winches all his life
And doesn't need to read manual or watch video
YOU MUST WATCH THE VIDEO
AND READ THE MANUAL
IF YOU CANNOT VIEW THE VIDEO VIA THE EMAIL OR ON THE WEBSITE, LET US
KNOW AND WE WILL POST OUT A DISC TO BE PLAYED ON YOUR COMPUTER.
If the winch is to be installed on a 4x4 bull bar, the motor must be on the same side as the driver,
This is because the winch has a one way clutch that works in one direction and can be damaged if installed incorrectly
If the winch is to be installed on a tray/trailer the motor must be installed on the passenger side
If still unsure, stand behind the winch, the motor will be on your right hand side, looking ahead that where you are pulling from
When operating winch with remote, clutch lever must be on full lock on the ENGAGED position,
DO NOT OPERATE WINCH UNLESS IN THIS POSITION
When free spooling, lever to be full lock in out position
Do not force the clutch lever into the in and out position
This process is engaging two gears together so in order to do this with ease
The drum may require movement backwards and forwards, this can be done using the remotes
Check all terminals are tight inside and outside of the black control box and on the winch
When winding winch in, cable must be evenly disbursed over the drum,
Failure to do so may cause casing to crack.
The battery used to power the winch must be minimum of 650 COLD CRANKING AMPS,
Do not use with battery that has a less CCA
Even if you have a dual battery system the 1 battery that the winch is connected to must be MIN 650CCA
NOT COMBINED TOTAL OF 2 BATTERIES
PLEASE READ AND UNDERSTAND THE INSTRUCTION BOOKLET THAT HAS BEEN PROVIDED WITH THE WINCH
|
| |
| |
|
|
|
